Navien Boiler Repair in Port Moody

Red Seal–certified Navien boiler repair for Port Moody homes and buildings. We diagnose E-prefix error codes (E003, E012…) shown on the front panel and get your heat and hot water back — same-day available.

Navien boilers — The most-installed condensing boiler brand in BC — which means parts everywhere and technicians who see these units daily. If yours is showing a fault in Port Moody, our Red Seal Gas Fitter–certified technicians service NCB-E condensing combis, NCB-H heating-only boilers and NFB fire-tube boilers (95%+ AFUE) across the Tri-Cities area.

Port Moody's heritage homes near Newport Village and modern Heritage Mountain residences both benefit from premium German (Viessmann) or Canadian-made (IBC) boiler installations.

Port Moody response time

Same-day available

604-359-1081

Common Navien Faults We Repair in Port Moody

Navien reports problems through E-prefix error codes (E003, E012…) shown on the front panel. These are the faults our technicians diagnose most often on Port Moody service calls:

  • E003Ignition Failure

    The unit attempts ignition three times and locks out — igniter wear, low gas pressure, a blocked gas valve, or a dirty flame rod. Damp Vancouver winters coating the electrode make this our most common Navien call.

  • E012Flame Loss During Operation

    The boiler lights but the flame drops mid-cycle — fluctuating gas pressure, a deteriorating gas valve, or combustion-chamber debris.

  • E110Water Temperature Sensor Fault

    The outlet sensor reads out of range — sometimes the sensor, often restricted primary-loop flow. We check zones and the circulator before replacing parts.

  • E016Overheating (High Limit)

    Unsafe temperature reached — blocked or air-locked heat exchanger, seized circulator, or excessive output demand. Needs same-day attention.

  • Frozen Condensate Line

    Exterior condensate runs freeze in cold snaps and lock the unit out until thawed and re-routed or insulated.

Navien Repair Cost in Port Moody

A diagnostic service fee applies and is credited toward the repair if you proceed. Typical repair ranges in BC:

RepairTypical range (CAD)
Igniter / flame-rod replacement$165$280
Gas-valve replacement (E003/E012 root cause)$360$560
Temperature sensor replacement (E110)$150$260
Condensate repair / freeze protection$150$320
Heat-exchanger descaling$220$320

We verify gas inlet pressure under full load on every Navien call — undersized or restricted gas supply masquerades as igniter failure more often than any other fault.

Why Port Moody Chooses Us for Navien Repair

Red Seal Gas Fitter–certified technicians
NCB igniters, flame rods & sensors always on the truck
Same-day parts via Navien’s BC distribution
The brand we repair most across Greater Vancouver

Navien repair across Port Moody: Inlet Centre · Glenayre · College Park · Heritage Mountain · Heritage Woods · Anmore · Belcarra · Pleasantside.

Red Seal Certified
All Navien Models
Same-Day Response
Parts In Stock

Navien Repair in Port Moody — FAQs

Do you repair Navien boilers in Port Moody?+

Yes. Our Red Seal Gas Fitter–certified technicians repair Navien NCB-E and NCB-H and NFB boilers throughout Port Moody and the surrounding Tri-Cities area. Response time is same-day available.

How much does Navien boiler repair cost in Port Moody?+

A diagnostic fee applies and is credited toward the repair if you proceed. Common Navien jobs in Port Moody: igniter / flame-rod replacement runs $165–$280, and gas-valve replacement (e003/e012 root cause) runs $360–$560. You receive a fixed price before any work begins.

How fast can you reach my Port Moody Navien boiler?+

Same-day available for Port Moody. Port Moody's heritage homes near Newport Village and modern Heritage Mountain residences both benefit from premium German (Viessmann) or Canadian-made (IBC) boiler installations.

What Navien faults are most common in Port Moody?+

The faults we see most often are E003 (Ignition Failure), E012 (Flame Loss During Operation), E110 (Water Temperature Sensor Fault). We diagnose the root cause rather than just clearing the code.

Are your technicians certified to repair Navien boilers in BC?+

Yes — every technician is Red Seal Gas Fitter certified and works to Technical Safety BC standards. NCB igniters, flame rods & sensors always on the truck.

Navien boiler down in Port Moody?

Talk to a Red Seal technician now — fixed quote before any work.

Need Navien boiler repair in Port Moody today?

Red Seal–certified technicians · fixed written quotes · 604-359-1081

Call NowFree Quote
After-Hours Emergency604-359-1081