Navien Boiler Repair in Burnaby

Red Seal–certified Navien boiler repair for Burnaby homes and buildings. We diagnose E-prefix error codes (E003, E012…) shown on the front panel and get your heat and hot water back — same-day, often within 90 minutes.

Navien boilers — The most-installed condensing boiler brand in BC — which means parts everywhere and technicians who see these units daily. If yours is showing a fault in Burnaby, our Red Seal Gas Fitter–certified technicians service NCB-E condensing combis, NCB-H heating-only boilers and NFB fire-tube boilers (95%+ AFUE) across the Burnaby/New West area.

Burnaby is our home base — we are headquartered here and respond fastest to Burnaby calls. IBC Boilers is also manufactured in Burnaby, making local parts access immediate for the most popular Canadian brand.

Burnaby response time

Same-day, often within 90 minutes

604-359-1081

Common Navien Faults We Repair in Burnaby

Navien reports problems through E-prefix error codes (E003, E012…) shown on the front panel. These are the faults our technicians diagnose most often on Burnaby service calls:

  • E003Ignition Failure

    The unit attempts ignition three times and locks out — igniter wear, low gas pressure, a blocked gas valve, or a dirty flame rod. Damp Vancouver winters coating the electrode make this our most common Navien call.

  • E012Flame Loss During Operation

    The boiler lights but the flame drops mid-cycle — fluctuating gas pressure, a deteriorating gas valve, or combustion-chamber debris.

  • E110Water Temperature Sensor Fault

    The outlet sensor reads out of range — sometimes the sensor, often restricted primary-loop flow. We check zones and the circulator before replacing parts.

  • E016Overheating (High Limit)

    Unsafe temperature reached — blocked or air-locked heat exchanger, seized circulator, or excessive output demand. Needs same-day attention.

  • Frozen Condensate Line

    Exterior condensate runs freeze in cold snaps and lock the unit out until thawed and re-routed or insulated.

Navien Repair Cost in Burnaby

A diagnostic service fee applies and is credited toward the repair if you proceed. Typical repair ranges in BC:

RepairTypical range (CAD)
Igniter / flame-rod replacement$165$280
Gas-valve replacement (E003/E012 root cause)$360$560
Temperature sensor replacement (E110)$150$260
Condensate repair / freeze protection$150$320
Heat-exchanger descaling$220$320

We verify gas inlet pressure under full load on every Navien call — undersized or restricted gas supply masquerades as igniter failure more often than any other fault.

Why Burnaby Chooses Us for Navien Repair

Red Seal Gas Fitter–certified technicians
NCB igniters, flame rods & sensors always on the truck
Same-day parts via Navien’s BC distribution
The brand we repair most across Greater Vancouver

Navien repair across Burnaby: Brentwood · Metrotown · Highgate · Edmonds · Capitol Hill · Burnaby Heights · Lougheed · Cariboo · Big Bend · Lakeview · Westridge.

Red Seal Certified
All Navien Models
Same-Day Response
Parts In Stock

Navien Repair in Burnaby — FAQs

Do you repair Navien boilers in Burnaby?+

Yes. Our Red Seal Gas Fitter–certified technicians repair Navien NCB-E and NCB-H and NFB boilers throughout Burnaby and the surrounding Burnaby/New West area. Response time is same-day, often within 90 minutes.

How much does Navien boiler repair cost in Burnaby?+

A diagnostic fee applies and is credited toward the repair if you proceed. Common Navien jobs in Burnaby: igniter / flame-rod replacement runs $165–$280, and gas-valve replacement (e003/e012 root cause) runs $360–$560. You receive a fixed price before any work begins.

How fast can you reach my Burnaby Navien boiler?+

Same-day, often within 90 minutes for Burnaby. Burnaby is our home base — we are headquartered here and respond fastest to Burnaby calls. IBC Boilers is also manufactured in Burnaby, making local parts access immediate for the most popular Canadian brand.

What Navien faults are most common in Burnaby?+

The faults we see most often are E003 (Ignition Failure), E012 (Flame Loss During Operation), E110 (Water Temperature Sensor Fault). We diagnose the root cause rather than just clearing the code.

Are your technicians certified to repair Navien boilers in BC?+

Yes — every technician is Red Seal Gas Fitter certified and works to Technical Safety BC standards. NCB igniters, flame rods & sensors always on the truck.

Navien boiler down in Burnaby?

Talk to a Red Seal technician now — fixed quote before any work.

Need Navien boiler repair in Burnaby today?

Red Seal–certified technicians · fixed written quotes · 604-359-1081

Call NowFree Quote
After-Hours Emergency604-359-1081