Navien Boiler Repair in Mission

Red Seal–certified Navien boiler repair for Mission homes and buildings. We diagnose E-prefix error codes (E003, E012…) shown on the front panel and get your heat and hot water back — next-day available.

Navien boilers — The most-installed condensing boiler brand in BC — which means parts everywhere and technicians who see these units daily. If yours is showing a fault in Mission, our Red Seal Gas Fitter–certified technicians service NCB-E condensing combis, NCB-H heating-only boilers and NFB fire-tube boilers (95%+ AFUE) across the Fraser Valley area.

Mission's hillside homes north of the Fraser and rural Stave Falls and Hatzic acreages often need carefully sized boilers and, on rural lots, propane conversions. We handle both modern condensing installs and retrofits of older Fraser Valley systems.

Mission response time

Next-day available

604-359-1081

Common Navien Faults We Repair in Mission

Navien reports problems through E-prefix error codes (E003, E012…) shown on the front panel. These are the faults our technicians diagnose most often on Mission service calls:

  • E003Ignition Failure

    The unit attempts ignition three times and locks out — igniter wear, low gas pressure, a blocked gas valve, or a dirty flame rod. Damp Vancouver winters coating the electrode make this our most common Navien call.

  • E012Flame Loss During Operation

    The boiler lights but the flame drops mid-cycle — fluctuating gas pressure, a deteriorating gas valve, or combustion-chamber debris.

  • E110Water Temperature Sensor Fault

    The outlet sensor reads out of range — sometimes the sensor, often restricted primary-loop flow. We check zones and the circulator before replacing parts.

  • E016Overheating (High Limit)

    Unsafe temperature reached — blocked or air-locked heat exchanger, seized circulator, or excessive output demand. Needs same-day attention.

  • Frozen Condensate Line

    Exterior condensate runs freeze in cold snaps and lock the unit out until thawed and re-routed or insulated.

Navien Repair Cost in Mission

A diagnostic service fee applies and is credited toward the repair if you proceed. Typical repair ranges in BC:

RepairTypical range (CAD)
Igniter / flame-rod replacement$165$280
Gas-valve replacement (E003/E012 root cause)$360$560
Temperature sensor replacement (E110)$150$260
Condensate repair / freeze protection$150$320
Heat-exchanger descaling$220$320

We verify gas inlet pressure under full load on every Navien call — undersized or restricted gas supply masquerades as igniter failure more often than any other fault.

Why Mission Chooses Us for Navien Repair

Red Seal Gas Fitter–certified technicians
NCB igniters, flame rods & sensors always on the truck
Same-day parts via Navien’s BC distribution
The brand we repair most across Greater Vancouver

Navien repair across Mission: Mission City · Hatzic · Cedar Valley · Silverdale · Stave Falls · Ferndale · Steelhead.

Red Seal Certified
All Navien Models
Same-Day Response
Parts In Stock

Navien Repair in Mission — FAQs

Do you repair Navien boilers in Mission?+

Yes. Our Red Seal Gas Fitter–certified technicians repair Navien NCB-E and NCB-H and NFB boilers throughout Mission and the surrounding Fraser Valley area. Response time is next-day available.

How much does Navien boiler repair cost in Mission?+

A diagnostic fee applies and is credited toward the repair if you proceed. Common Navien jobs in Mission: igniter / flame-rod replacement runs $165–$280, and gas-valve replacement (e003/e012 root cause) runs $360–$560. You receive a fixed price before any work begins.

How fast can you reach my Mission Navien boiler?+

Next-day available for Mission. Mission's hillside homes north of the Fraser and rural Stave Falls and Hatzic acreages often need carefully sized boilers and, on rural lots, propane conversions. We handle both modern condensing installs and retrofits of older Fraser Valley systems.

What Navien faults are most common in Mission?+

The faults we see most often are E003 (Ignition Failure), E012 (Flame Loss During Operation), E110 (Water Temperature Sensor Fault). We diagnose the root cause rather than just clearing the code.

Are your technicians certified to repair Navien boilers in BC?+

Yes — every technician is Red Seal Gas Fitter certified and works to Technical Safety BC standards. NCB igniters, flame rods & sensors always on the truck.

Navien boiler down in Mission?

Talk to a Red Seal technician now — fixed quote before any work.

Need Navien boiler repair in Mission today?

Red Seal–certified technicians · fixed written quotes · 604-359-1081

Call NowFree Quote
After-Hours Emergency604-359-1081