Lochinvar Boiler: Error code on display
A fault code on a Lochinvar boiler is the control telling you which safety system tripped. It is a starting point, not a full diagnosis — the same code can have several root causes, which is why a technician confirms the cause before repairing.
A fault code on a Lochinvar boiler is the control telling you which safety system tripped. It is a starting point, not a full diagnosis — the same code can have several root causes, which is why a technician confirms the cause before repairing. On Lochinvar boilers, this is linked to 2 fault codes (Ignition Failure, Flame Loss). Below are the likely causes, the safe checks you can make, and exactly what our licensed BC gas technicians do — because boiler repair in British Columbia is licensed gas work, not a DIY job.
This is a gas-safety fault. Diagnosing ignition, flame, gas or venting problems requires combustion analysis and gas-pressure testing that, by BC law, only a licensed gas technician may perform. Never bypass a safety lockout. Smell gas? Leave the building and call 911 or FortisBC at 1-800-663-9911 from outside.
What you might notice
- No heat or no hot water
- Boiler attempts to fire (you may hear clicking) then locks out
- Repeated lockouts after a few ignition attempts
- Boiler fires briefly then shuts down
- Intermittent heat or hot water
- Short-cycling with lockouts
Safe checks you can make first
These are the only steps a homeowner should take. If they don’t resolve it, stop — the rest is licensed gas work.
- 1Write down the exact code shown
- 2Look it up in our Lochinvar error-code reference
- 3Reset at most once after a one-off event
- 4If the code returns, switch the boiler off and call us
Related Lochinvar fault codes
These Lochinvar codes are commonly behind “error code on display”. Tap any code for its full meaning, causes and fix.
What our licensed technicians do
- Verify incoming gas supply and lock-up/working gas pressure with a manometer
- Inspect and clean the igniter and flame-sensing electrode, checking the spark gap
- Test the gas valve operation and ignition control sequence
- Run a full combustion analysis to confirm a safe, clean flame after repair
- Measure flame-rectification current (microamps) during firing
- Clean or replace the flame-sensing electrode and check its ground path
Lochinvar error code on display — FAQ
My Lochinvar boiler is showing an error code — what should I do?
A fault code on a Lochinvar boiler is the control telling you which safety system tripped. It is a starting point, not a full diagnosis — the same code can have several root causes, which is why a technician confirms the cause before repairing. The related Lochinvar fault codes are Ignition Failure, Flame Loss. A licensed technician confirms the true root cause with the right instruments before any repair.
Is it safe to keep resetting my Lochinvar boiler when it shows "error code on display"?
No. A single reset after a one-off event is fine, but "error code on display" involves gas, ignition, flame or venting safety. Repeated resets without fixing the cause can be dangerous and can damage the boiler. If the fault returns, switch the boiler off and call GasBoilers.ca at 604-359-1081. If you ever smell gas, leave the building and call 911 or FortisBC at 1-800-663-9911 from outside.
Can you repair a Lochinvar boiler with this problem in Greater Vancouver?
Yes. Our Red Seal–certified, TSBC gas-licensed technicians diagnose and repair Lochinvar Knight, WHN and SMART System series across Vancouver, Burnaby, Surrey, Richmond, the Tri-Cities and the rest of Greater Vancouver. Same-day appointments are often available — call 604-359-1081.
“Error code on display” on other boiler brands
Lochinvar boiler error code on display? We can help today.
Licensed, Red Seal–certified gas technicians across Greater Vancouver. Upfront pricing, same-day service available.