Burnham Boiler: Gas-valve fault
Faults tied to the gas valve or gas supply on a Burnham boiler — pressure, the valve itself, or its modulation — stop the boiler firing safely. In BC, anything touching the gas valve or gas pressure is legally licensed gas-fitter work.
Faults tied to the gas valve or gas supply on a Burnham boiler — pressure, the valve itself, or its modulation — stop the boiler firing safely. In BC, anything touching the gas valve or gas pressure is legally licensed gas-fitter work. On Burnham boilers, this is linked to 1 fault code (Ignition Lockout). Below are the likely causes, the safe checks you can make, and exactly what our licensed BC gas technicians do — because boiler repair in British Columbia is licensed gas work, not a DIY job.
This is a gas-safety fault. Diagnosing ignition, flame, gas or venting problems requires combustion analysis and gas-pressure testing that, by BC law, only a licensed gas technician may perform. Never bypass a safety lockout. Smell gas? Leave the building and call 911 or FortisBC at 1-800-663-9911 from outside.
What you might notice
- No heat or no hot water
- Boiler attempts to fire (you may hear clicking) then locks out
- Repeated lockouts after a few ignition attempts
Safe checks you can make first
These are the only steps a homeowner should take. If they don’t resolve it, stop — the rest is licensed gas work.
- 1Confirm the gas is on and other gas appliances work normally
- 2Check the gas isolation valve handle is in line with the pipe
- 3Note the fault code on the display
- 4Never adjust gas pressure or the gas valve yourself — call a licensed gas technician
Related Burnham fault code
These Burnham codes are commonly behind “gas-valve fault”. Tap any code for its full meaning, causes and fix.
What our licensed technicians do
- Verify incoming gas supply and lock-up/working gas pressure with a manometer
- Inspect and clean the igniter and flame-sensing electrode, checking the spark gap
- Test the gas valve operation and ignition control sequence
- Run a full combustion analysis to confirm a safe, clean flame after repair
Burnham gas-valve fault — FAQ
What does a gas-valve or gas-supply fault on my Burnham boiler mean?
Faults tied to the gas valve or gas supply on a Burnham boiler — pressure, the valve itself, or its modulation — stop the boiler firing safely. In BC, anything touching the gas valve or gas pressure is legally licensed gas-fitter work. The related Burnham fault code is Ignition Lockout. A licensed technician confirms the true root cause with the right instruments before any repair.
Is it safe to keep resetting my Burnham boiler when it shows "gas-valve fault"?
No. A single reset after a one-off event is fine, but "gas-valve fault" involves gas, ignition, flame or venting safety. Repeated resets without fixing the cause can be dangerous and can damage the boiler. If the fault returns, switch the boiler off and call GasBoilers.ca at 604-359-1081. If you ever smell gas, leave the building and call 911 or FortisBC at 1-800-663-9911 from outside.
Can you repair a Burnham boiler with this problem in Greater Vancouver?
Yes. Our Red Seal–certified, TSBC gas-licensed technicians diagnose and repair Burnham Alta, Aspen and Independence series across Vancouver, Burnaby, Surrey, Richmond, the Tri-Cities and the rest of Greater Vancouver. Same-day appointments are often available — call 604-359-1081.
“Gas-valve fault” on other boiler brands
Burnham boiler gas-valve fault? We can help today.
Licensed, Red Seal–certified gas technicians across Greater Vancouver. Upfront pricing, same-day service available.